Galaxy
DX Radios DX73V
Documentation Project
CBTricks.com
Frequency
Conversion
Export Frequency Conversion
|
1.
|
Remove
the bottom cover from the unit and locate the Selector board just behind
the Channel Selector. Unsolder and remove the short jumper wire on the
rear of the Selector Board as shown above. |
| 2. | Locate the loose ends of the Gray and Yellow wires coming from the center plug on the Selector Board and Re-Solder them back together. Be sure to use Heat Shrink tubing or any suitable type of insulating material. |
| 3. | Locate
the small keyed connector plug hanging loose near the Selector Board and
plug it back into it's socket as shown in the Diagram above (Purple Wire
on the Left). |
WARNING! Not Legal For Class D CB Use In The U.S.A.
Disclaimer: Although the greatest care has been taken while compiling these documents,
we cannot guarantee that the instructions will work on every radio presented.