Texas Star Skeleton 220
Documentation Project
CBTricks.com
Texas Star Skeleton 220 CW Transmitter To AMP Conversion

1. Remove the black wire of the oscillator board from CW keying jack
2. Remove and discard black wire of keying jack from bare ground wire
3.

Remove red wire of oscillator board from red LED lead
4. Remove the green wire of oscillator board and the attached 33pf cap
5. Solder the leg of the 15/18pf cap to bare wire of radio SO239 connector
6. Remove yellow 2200K cap from teflon wire of input transformer
7. Unsolder the 56pf cap from teflon wire and also from ground tab
8. Solder the teflon wire to junction of the 200ohm resistor and 180pf cap
9. Solder lead of 56pf cap to the teflon wire on small relay from transformer
10. Solder other lead of 56pf cap to bare ground wire from antenna connector
11. Unsolder oscillator board from input transformer

 

Please Note the Warnings Below!

WARNING! This is a violation of FCC rules for Class D CB use in the U.S.A. The user is solely responsible for making sure that any modifications made to the unit must meet all Federal and State Regulations for the Country of use! Liability of damages to any equipment is the sole responsibility of the user! This information is not provided by, or affiliated in any way with the manufacturer of the products.

 

Copyright © 2001, 2002, 2003, 2004, 2005, 2006 CBTricks.com
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, mechanical, photocopying, or otherwise, without the prior written permission of the copyright holder (CBTricks.com).
All logos and Brand Names are the property of their respective owners.
http://www.cbtricks.com/

Disclaimer: Although the greatest care has been taken while compiling these documents,

we cannot guarantee that the instructions will work on every amp presented.