Texas Star DX 1000V
This amplifier was introduced in February 2007.
It has 8 x SD1446 Transistors.
Overview
Class AB
(works on SSB, CW, AM and FM).
There is a SSB Delay Switch.
Variable power control.
Preamp to amplify receive
Power Output: approx.. 1000 Watts
13.8 DC Volts
Automatic thermal shutdown switch to protect amplifier from overheating.
Conversion is similar to the other Texas Star units is available
here.
There is switch to
allow the fan to operate in manual (remain on constant) and automatic
(thermally) when needed.
The Fan on the top cover pulls air in the top cover across the amplifier
chassis out through hole in the chassis bottom behind the meter/front
panel. Then the cooling air moves across the heatsink on the bottom and
out the back.
Fan Data
Manufactured by JMC Datech. Model 1225-12HBA.
12Vdc/600mA, 120mm (4.72") x 25mm (1"),dual ball bearing, 88CFM,45dBA,
7 blade, and 2600RPM.
Input Power
2 to 80 watts.
Remote:
Uses the same remote for the DX 1200 / DX 1600 and DX 2400 / DX 3200.
Front Panel Controls
POWER (On and Off)
REC AMP (Preamp to amplify receive)
DIAL A WATT (Variable Power Control On / Off)
Rear Panel Controls
DLY Switch (SSB Delay Switch)
FAN Switch (ON constant or automatic thermal control)
Jacks (Rear Panel)
RADIO (RF Input)
ANT (RF Output)
Key (for use as a CW Transmiter)
FAN (Fan Kit power or Remote Control)
NOTE: The Mode of this Jack is controled my a switch on the Control PCB
inside
the Amp. (You can set it for Remote or Fan but Not Both)